Simple Holiday Wreath

I shared with you a couple weeks ago about my new go to site for ordering craft supplies, consumer crafts. I gave you a sneak peek of some of the supplies I was ordering and now I am going to show you exactly what I made with them!

Supply List

Start off by laying your supplies out and placing them. I started with the pine branch and then stuck the red berry sprays in around them. Everywhere they touched the wreath I covered them in hot glue. Don’t worry if it’s ugly, you are going to cover most of it up with the flowers.

Once all the big stuff is glued down you will want to figure out exactly where to place your flowers. My flowers were taped too low for where I wanted to place them so I wrapped them in some gold washi tape and cut off the excess stem. Then I added a big glob of hot glue and stuck them down.

Once everything was glued down, make sure you trim off all the excess stems and branches. Then add a piece of twine to the top of the wreath so that you can hang it. Tie it directly onto the wreath form and hang it up! As an added bonus check out the rafflecopter below for your chance to win a Cricut!

a Rafflecopter giveaway